System Behaviour With "Auto" Mode Enabled - Lenz Digital plus LH101 Mode D'emploi

102
the speed of called-up locomotives even after turnoff. After turnon, all
locomotives will start with their previous speed.
To enable the mode:
Action

15.2.1 System behaviour with "AUTO" mode enabled

If you turn the LZ100/LZV100/LZV200 command station on while the
"AUTO" mode is enabled, you will see the following display:
Display
Proceed from "Controlling a locomotive".
Change to the general menu.
Turn the rotary knob until the option "Setup
System/System Setup" is displayed.
Press the rotary knob to select this option.
Turn the rotary knob until the option
"AUTO"-Mode.
The current status of the "AUTO" mode is
displayed (ex-factory, the mode is disabled).
Turn the rotary knob to change the setting ...
... and press the button to confirm the setting.
Press the 'ESC' key to leave the menu
without changing the setting.
The
locomotive".
Operating manual LH101
Explanation
LH101 returns
to "Controlling