Lenz Digital plus LH101 Mode D'emploi page 143

Controlling locomotives
The locomotive-specific emergency stop is not available in
the shunting mode. If you press the rotary knob, the
locomotive stops with the braking delay set in the
locomotive decoder.
5.2.2 Shunting mode
While in shunting mode, use the rotary knob to decrease the speed
step to 1. Press the rotary knob to stop the locomotive.
Let the locomotive move slowly to the desired location and press the
rotary knob
The advantage of this mode while shunting: You can decrease the
speed to the slowest setting without risking that the locomotive stops
too early and without having to look at the manual control.
Action
to
Display
A clockwise turn increases the speed step.
A counter clockwise turn decreases the
speed step...
... to speed step 1.
Press the rotary knob to stop the locomotive
(speed step 0).
Press the rotary knob again to change the
direction of travel.
stop the
Explanation
23
locomotive.