System Setup - Lenz Digital plus LH101 Mode D'emploi

System setup

15 System setup
System settings are settings that do not only affect individual
locomotives but the entire digital system.
These settings are saved permanently in the command station
(LZ100/LZV100/LZV200).
15.1 Setting the fast clock
This option is available from LZV200 version 3.8.
A fast clock is integrated in the LZV200 command station. You can set
the day of the week, the hours and minutes, and the time factor.
If the time factor = 0, the time is off, factor 1 is "normal" speed, factor
2 is double speed etc. up to factor 31.
The fast clock only runs while your LZV200 is in operation. If the
LZV200 is switched off, the fast clock is also stopped. The last model
time remains stored in the LZV200.
If the fast clock was active while the LZV200 was switched off, it is
automatically restarted when the LZV200 is switched on again.
Action Display
The starting point is locomotive control ...
... switch to the general menu.
Turn the knob until the "Setup System" option
is displayed.
... and confirm by pressing the rotary knob.
If necessary, turn the rotary knob until the
"clock setting" option is visible.
Press the rotary knob to select the option.
Explanation
99