Lenz Digital plus LH101 Mode D'emploi page 192

72
13.3.2 Where to connect the programming track/the decoder?
The Digital plus command stations LZ100, LZV100 and LZV200 have
special connection terminals for the programming track (or the
decoder). These connections are labelled P and Q. More information
can be found in the operation manual of the respective command
station.
13.3.3 Reading out and changing a locomotive address
Step-by-step approach to reading out a locomotive address:
Action Display Explanation
Proceed from "Controlling locomotive".
Change to the general menu.
Select "Programmieren auf dem
Programmiergleis/Programming on the
programming track" ...
... and confirm your selection.
Turn the rotary knob until "Programmieren
Lokadresse/Programming locomotive
address" is displayed...
... and confirm your selection.
The locomotive address is read out. This
takes a few seconds.
If the address was successfully read out, it
will be displayed. If an error occurred during
the reading-out process, you will receive an
error message (p. 79).
If you want to change the displayed address,
you will have to clear the display first.
Now enter the desired new address using the
keypad...
(press the
necessary).
Operating manual LH101
key to correct your entry if