Editing A Route - Lenz Digital plus LH101 Mode D'emploi

36
Press the 'M' key again to send a corresponding switch command to the
point/signal. This way you can verify if you have selected the correct
point and the correct setting.
Press the 'point/signal' key to confirm the entries relating to this step.
The step is now saved.
...or...
...or...

7.2 Editing a route

In this section, you will learn how to:
edit a step in the route
-
delete a step from a route
-
add a new step to a route
-
The beginning of the editing process is the same for all three options:
Action
Press the 'M' key to enter the desired
point/signal setting.
The next step of the route is offered for entry.
You can now proceed to the next step of the
route and enter the next point address...
... press the 'M' key to save the route and to
proceed to enter another route...
(The display remains visible for 2 s)
... press the 'Esc' key to leave the routes
menu and return to "Controlling locomotive".
The route will be saved.
Display
Proceed from "Controlling locomotive".
Use the 'points/signals' key to change to the
menu for switching points and signals.
Press the M' key again to change to creating
(or editing/deleting) routes.
Operating manual LH101
Explanation