Changing The Locomotive`s Speed And Direction; Standard Mode - Lenz Digital plus LH101 Mode D'emploi

Controlling locomotives
If you do not want to take over the locomotive
Press the 'Esc' key to change back to the locomotive
controlled before or
select another locomotive address.

5.2 Changing the locomotive`s speed and direction

To control the speed and direction, two methods are available:
the standard mode (ex-factory setting):
-
In this mode, use the rotary knob to decrease the speed step to
0.
- The shunting mode:
In this mode, use the rotary knob to decrease the speed to 1.
Press the rotary knob to stop the locomotive.
Let the locomotive move slowly to the desired location and press
the rotary knob to stop the locomotive.
The advantage of this mode while shunting: You can decrease
the speed to the slowest setting without risking that the
locomotive stops too early and without having to look at the
manual control.
Read the section "Setting the speed step mode" starting on page 80 to
learn how to set the standard mode as well as the shunting mode.
Do not confuse the shunting mode of the LH101 with the
shunting gear that can be set in locomotive decoders.
5.2.1

Standard mode

Use the rotary knob to control the speed and the direction of the
locomotive.
21