Deleting Locomotive Addresses From The Command Station Memory - Lenz Digital plus LH101 Mode D'emploi

Masquer les pouces Voir aussi pour Digital plus LH101:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

104
15.4 Deleting locomotive addresses from the
command station memory
The LZ100/LZV100/LZV200 command station repeatedly sends
operating data to all locomotive addresses contained in its memory.
To avoid sending more addresses than necessary (and to optimise the
reaction time), you can delete locomotive addresses from the memory
that are not required for operation.
To delete locomotive addresses from the command station memory,
proceed as follows:
Action
Display
Select the locomotive address that is to be
operated.
Press the 'M' key.
Turn the rotary knob until the option "Setup
System/System setup" is displayed.
Press the rotary knob to select this option.
Turn the rotary knob until the option "Loco
addr. from stack delete" is displayed.
Operating manual LH101
Explanation

Publicité

Table des Matières
loading

Table des Matières