Lenz Digital plus LH101 Mode D'emploi page 189

Configuring (programming) decoder settings 69
Use the keypad to enter the number of the
CV ...
... and press the 'locomotive' key to complete
the entry process.
Press the 'M' key.
Use the rotary knob to select the bit that you
want to change.
Press the rotary knob to confirm your
selection.
Turn the rotary knob to set the bit (1) or to
delete the bit (0).
Press the knob to start programming.
While programming you see this display.
Press the 'Esc' key to return to selecting the
bit ...
... press the 'Esc' key again to select the CV.
You can now select another CV that you want
to change or ...