Lenz Digital plus LH101 Mode D'emploi page 185

Configuring (programming) decoder settings
•
If the decoder from which PoM values are to be read out is not
within the supply range of the LZV200, an LV103 must be used
as amplifier.
13.2.4 Programming a numeric value into a CV — step by step
approach:
In the following example, we will change the starting delay of the
locomotive with address 3 using PoM
Before you switch to PoM, you must call up the address of the
locomotive whose settings you want to change
Action
Provided that the requirements described in section 13.2.3 "Can PoM
be used to read values from Cvs? (
the entered CV is now read out by RailCom and displayed:
Display
Call up the locomotive whose settings you
want to change using PoM.
Press the 'locomotive' key.
Press the 'M' key. You are offered the option
last used (in this example the locomotive
selection from the command station memory).
Turn the rotary knob until "Programmieren
während des Betriebs PoM/Programming in
operational mode PoM" is displayed.
Press the rotary knob to select the option
"PoM". You are asked to enter the CV that
you want to change using PoM.
Use the keys to enter the number of the CV
...
(use the
necessary)
:
Explanation
key to correct your entry if

p. 64) are fulfilled, the value of
65
!