Assembling A Multiple Traction (Mtr) - Lenz Digital plus LH101 Mode D'emploi

Multiple traction (MTR)
provided they support the MTR function. Further information can be
obtained from the manufacturers of these decoders.
All locomotives that you want to add to an MTR must be
located on the layout! Only then can the locomotive
decoders receive the special MTR commands sent over
the track!
- The addresses of all locomotives that you want to add to a
multiple traction must be in the stack of the manual control that
you want to use to assemble the multiple traction.
- You must have given an operating command to each locomotive
(i. e. change the speed or direction or turn a function on or off)
using this manual control.
- When being added to the multiple traction, the speed step of the
locomotives must be 0.

11.3 Assembling a multiple traction (MTR)

Drive all locomotives that you want to add to the MTR to the location
on your layout where you want to start controlling the MTR.
Ensure that all locomotives are set to run into the same direction. If
your MTR is meant to drive to the right, the direction of each
locomotive must be set to the right. Note that the direction arrow in the
LH101`s display may point up or down.
Now, begin to assemble your MTR:
Action Display
Call up the first locomotive that you want to
add to the MTR.
Press the 'M' key.
Turn the rotary knob until you reach the
option " Mehrfachtraktion/Multiple traction".
Explanation
51