Configuring Locomotive Decoder Functions - Lenz Digital plus LH101 Mode D'emploi

26
5.3.2

Configuring locomotive decoder functions

Functions F1 to F28 can be set to permanent or temporary operation.
Function F0 is always set to permanent operation.
Permanent operation
Press the key to enable the
function; press the key again
to disable the function
This setting is saved in the command station. When calling up the
locomotive, the manual control queries the setting from the command
station. This setting can be made individually for each function and
each locomotive address.
Action
.
Display
Call up the locomotive address whose
function setting you want to display or
change.
Press the 'F' key and keep it pressed until
the display changes.
Release the 'F' key and turn the rotary knob
until you reach this display.
Press the rotary knob; the configuration of
function 1 is displayed.
Turn the rotary knob until the function is
displayed that you want to set to permanent
or temporary operation.
Press the rotary knob to switch between
permanent and temporary operation.
Turn the rotary knob to select the next
function whose configuration you want to
change ...
Operating manual LH101
Temporary operation
Press the key to enable the
function; release the key to
disable the function.
Explanation