24
If, while in shunting mode, the speed step is larger than 0
and you press the rotary knob, the locomotive will stop
with the braking delay set in the locomotive decoder.
Read the section "Setting the speed step mode" starting on page 80 to
learn how to enable (or disable) the shunting mode.
A small dot on the display indicates whether the LH101 is set to the
shunting mode:
5.3 Enabling functions in locomotive decoders
All Digital plus by Lenz
special functions. The functions are numbered, beginning with 0.
Altogether the Digital plus by Lenz
to F68) functions in locomotive decoders.
The use of 69 functions requires the use of an LZV200
from version 4.0.
Older versions of Lenz control panels support up to 29
functions.
For the LH101, these 69 functions are divided into 7 function groups
(Fg0 bis Fg6). Which of these groups is enabled is indicated at the
bottom left of the display:
Depending on the selected function group (0 to 6), the following
functions are switched:
Key:
Function group 0:
®
locomotive decoders have one or more
®
system can address up to 69 (F0
0
1
2
3
Operating manual LH101
4
5
6
7
8
9