Resetting The Decoder - Lenz Digital plus SILVERmini+ Mode D'emploi

34
You can alter the content of CVs both through "Programming in operational mode (PoM)" (except
for CV1, CV17 and CV18) or "Programming on the programming track".
For detailed instructions on how to program a decoder, please refer to the operating manuals which
accompany the devices you are using.
The decoder is programmed ex-works for operation with address 3 and 28 running notches. The
decoder can be used with these basic configurations immediately after purchase. All configurations
can, of course, be changed.

6.1 Resetting the decoder

If you wish to reset all the decoder CVs to the ex-works setting, enter value 8 or 33 in CV8.
7 Table of supported CVs
Value /
CV Meaning
Bit
1-127 Basic locomotive address. This number is used to call up
1
locomotives in the Digital plus by Lenz
range 1-99 is recommended for operation with
Digital plus by Lenz
When writing this CV, CV19 (multiple traction address) is
automatically deleted in the decoder and Bit 6 (use of extended
address) is deleted in CV29.
0-255
2 Minimum starting voltage
0-255 Starting delay
3
4 0-255 Braking delay
®
®
devices.
Information SILVERmini+ S.U.S.I.
system. The use of
Ex-works
setting
3
1
6
5