Updating Your Atem Mini; Configure Page - Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation

Updating your ATEM Mini

To update your ATEM Mini, simply connect the unit to your computer via USB or Ethernet.
Launch ATEM Setup. If the software version installed on your computer is newer than the
version installed on your ATEM Mini, a dialogue box will appear notifying you of an update.
Simply click on the 'update' button and follow the prompts to update the unit.
A progress bar will appear with a notification to let you know when the update is complete.

Configure Page

Panel Settings
Switching Mode
This setting lets you set ATEM Mini to use program preview or cut bus switching modes. Refer
to the 'Switching Modes' section for more information.
Picture in Picture Keyer
This setting lets you choose to keep the picture in picture on screen indefinitely so you can
switch content underneath it, or tie it to the next transition so when you perform the transition,
picture in picture will transition off screen with it.
Drop with Transition
Stay on with transition
TIP Drop with transition lets you smoothly turn off picture in picture by linking it
with the transition, however you can always turn picture in picture off at any time
by pressing the respective off button on the control panel.
Ties picture in picture to the next transition and will transition off
screen when the next transition is performed.
Holds picture in picture on air so you can switch sources without
affecting picture in picture.
ATEM Mini Setup Settings 76