Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation page 101

Adding DVE Borders
DVE border parameters
The upstream key LCD menu is used to adjust the border parameters for the DVE and picture
in picture.
Border
Color
Hue
Saturation
Luminance
Style
Outer Width
Inner Width
Outer Soften
Inner Soften
Border/Shadow
Opacity
Bevel Position
Bevel Soften
DVE shadow light source parameters
Enable Shadow
Angle
Altitude
Enables or disables the border.
This item appears greyed out because it is not a setting, but rather
an indicator to show you the selected border color. You can use this
indicator to quickly verify the color of the DVE border.
Changes the border color. The hue value is a location on the color
wheel.
Changes the intensity of the border color.
Change the brightness of the border color.
Sets the bevel style for the DVE border.
Adjusts the outside width of the border.
Adjusts the inside width of the border.
Outside softness adjusts the outside edge of the border, the edge that
touches the background video.
Adjusts inside softness. This softness parameter adjusts the inside
edge of the border, the edge that touches the video.
Opacity adjusts the transparency of the border and shadow, use this
setting to create interesting colored glass borders.
Adjusts the position of the 3D bevel on the border.
Bevel softness adjusts the overall softness of the 3D border. A high
value for this parameter will result in a rounded or beveled border.
Enables or disables the drop shadow.
Adjusts the direction of the light source on the DVE or picture in picture.
Both the border and drop shadow, if available, are affected by changes to
this setting.
Adjusts the distance of the light source from the DVE or picture in picture.
Both the border and drop shadow, if available, are affected by changes to
this setting.
Keying using ATEM Mini 101