Setting The Switcher's Ip Location On The Panel - Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 310
4
If you have elected to use a fixed IP address, you now need to set this IP address by
adjusting the corresponding soft control knobs for each field of the IP address.
You can also use the numeric keypad. Changing this IP address may cause the panel
to lose communication.
5
If the subnet mask and gateway address need to be set, then press the right arrow
button in the system control buttons to progress through each setting menu, and use
the knobs or the numeric keypad to edit. If at any time you want to cancel the changes,
press 'undo'.
6
When you are happy with your settings, press the 'save changes' soft button to confirm.
When you are happy with your network settings,
press the 'save changes' button to confirm them

Setting the Switcher's IP Location on the Panel

To set ATEM Mini's IP location on ATEM 1 M/E Advanced Panel so the panel can find ATEM Mini
and communicate, simply follow these steps:
Changing the Switcher's IP location on ATEM 1 M/E Advanced Panel
1
When there is no communication with ATEM Mini, the LCD will say 'connecting'
and notify you of the IP address it is searching for. If the panel can't find the switcher,
the connection will time out and a notification will ask you to check the IP address.
Press the 'network' soft button above the LCD to open the network settings.
2
In the network settings, press the right arrow in the system control buttons next to the
LCD to move to the 'switcher IP address' setting.
3
Now use the corresponding LCD soft control knobs to set the correct IP address for
your switcher.
4
Press the 'save changes' soft button to confirm the setting.
Your panel will now connect with your switcher.
Connecting to a Network
86

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Atem mini pro

Table des Matières