Using Atem Camera Control Panel - Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 310

Using ATEM Camera Control Panel

Traditionally, camera control units, or CCUs, have been designed for mounting inside a desk
with independent units for each camera. ATEM Camera Control Panel is a portable solution that
can be placed on a desk or solid surface with 4 CCUs built in so you can control all four
Blackmagic Pocket Cinema Cameras at once.
Powering the Panel
To power your camera control panel, connect power via the IEC power input on the rear panel
using a standard IEC power cable. You can also use the 12V DC input if you want to connect
external power or redundancy via an external power supply, for example a UPS uninterrupted
power supply or external 12V battery.
Connect power via the power input on the rear panel
Connecting the Panel to your Switcher
To connect ATEM Camera Control Panel to your switcher, all you need to do is add the panel
into your ATEM Ethernet connection chain.
For example, if you are using an external ATEM hardware panel, such as the ATEM 1 M/E
Advanced Panel, remove its Ethernet cable from your computer or network and connect it to
one of the camera control panel's Ethernet ports instead. The ATEM hardware panel will then
be the middle unit in the chain. Now connect the camera control panel's spare Ethernet port to
your computer or network.
Using ATEM Camera Control Panel
133

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Atem mini pro

Table des Matières