Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation page 108

In addition to the text color, each HyperDeck's selection button also has a tally indicator.
Green Outline
Red Outline
Ready
Record
No Disk
Local
When you select a HyperDeck, you'll see information about the currently selected clip such as
the name and length, as well as time elapsed and time remaining. Below this you'll see the
control buttons.
Record
Previous Clip
Play
Next Clip
Loop
To move through a clip use the shuttle/jog slider underneath your HyperDeck's control buttons.
This lets you move quickly, or shuttle through a selected clip, or jog frame by frame. You can
switch between these modes with the buttons next to the shuttle/jog slider.
Choose between shuttle and jog transport controls with the
buttons to the left of the transport slider. Adjust the slider left
and right to move forward or backwards through your clip.
The clip list below the transport control shows all of the clips currently available on the selected
HyperDeck. You can expand or collapse the list by pressing the arrow to the right of the clip list.
Indicates a HyperDeck that is currently switched to the preview output.
Indicates a HyperDeck that is currently switched to the program output,
meaning it is currently live to air.
You may also see one of the following status indicators above the
selection buttons for your HyperDecks.
HyperDeck is set to remote and a disk is inserted. It is ready for
playback and recording if space is available.
HyperDeck is currently recording.
HyperDeck has no disk inserted.
HyperDeck is not set to 'remote' and cannot currently be
controlled by your ATEM switcher.
Click on this button to start recording on your HyperDeck.
Click again to stop recording.
Moves to the previous clip in your HyperDeck's media list.
Clicking 'play' once initiates playback, clicking it again stops playback.
If you have 'auto roll' enabled in your HyperDeck settings, playback
will commence automatically when your HyperDeck is switched to the
program output.
Moves to the next clip in your HyperDeck's media list.
Click 'loop' once to loop the currently selected clip, and again to loop
all of the clips in your HyperDeck's media list.
HyperDeck Control 108