Updating Your Smart Remote 4; Uninstalling Ultimatte Sr4 V1.0.5; Ultimatte Smart Remote - Blackmagic Design Updating Ultimatte Smart Remote 4 Mode D'emploi

Updating your Smart Remote 4

If you have SR4 software 1.0.5 or earlier installed, you will need to first uninstall the SR4
software from your smart remote using the built in Ultimatte maintenance tool.
NOTE If you have previously installed Smart Remote 4 software using the Ultimatte
Smart Remote Setup installer from the Blackmagic Design support center, then you can
skip this uninstall process and go straight to the 'installing Ultimatte Smart Remote
Setup' section.

Uninstalling Ultimatte SR4 v1.0.5

The first step to uninstalling the SR4 software is to ensure the application is not running.
To quit the SR4 software:
1 Tap on the 'info' icon in the Smart Remote 4 file control section of the control panel.
2 In the 'options' tab, tap on the 'exit to desktop' button.
3 Now that the desktop is visible, tap on the 'up' arrow in the Windows tray.
4 Tap and hold the Ultimatte SR4 icon for 2 seconds then release. The 'quit' icon will
appear. Simply tap on the 'quit' icon to close the application.
MATTE MENU
Uninstalling Ultimatte SR-4 v1.0.5 4