Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation page 81

The following section describes how to connect your ATEM equipment to a network so you can
operate your switcher using an ATEM hardware panel and multiple computers running
ATEM Software Control.
TIP If you are using 4 Blackmagic Pocket Cinema Camera 4Ks or 6Ks with ATEM Mini,
you can even connect an ATEM Camera Control Panel and control all 4 cameras via
HDMI using an external hardware control panel.
When connected to a network via Ethernet, multiple computers can run ATEM Software Control
simultaneously, which means multiple operators can be dedicated to separate controls on your ATEM Mini.
For example, multiple operators can control media management, camera control and audio mixing.
TIP For detailed information about how to control your ATEM Mini using ATEM 1 M/E
Advanced Panel refer to the 'using the ATEM 1 M/E Advanced Panel' section.
Using Multiple Control Panels 81