Labels Settings; Hyperdeck Settings - Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation

Labels Settings

Label settings
The input labels settings let you customize the name of each input using a long and short name.
The short name will appear on the switcher input buttons on the software panel. If you are using
an additional ATEM broadcast panel, the long and short labels allow for the short label to fit into
the broadcast panel's smaller display. The short 4 character name is used to identify the video
input on the source names display. The longer input names support up to 20 characters and are
displayed in various dropdown source selection boxes on the software control panel.
To change an input name, click in the text field, enter the text and click 'save'. The input name
will be updated on the software control panel and external hardware panel if one is connected.
It's a very good idea to change both the short and long labels at the same time, so they match.
For example Camera 1 would be entered in as a long label, and CAM1 as the short label.

HyperDeck Settings

HyperDeck settings
You can connect up to 4 Blackmagic HyperDeck Studio disk recorders to a network via
Ethernet and control them using ATEM Software Control. When connecting HyperDecks, use
these settings to configure the IP Address, select the inputs your HyperDecks are connected
to, turn the auto roll feature for each deck on or off, and set their frame offset settings so they
can switch cleanly.
Changing Switcher Settings 70