Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation page 130

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 310
Graphic wipe images
The graphic wipe feature requires a static graphic that is used as a moving border for a
horizontal wipe. This graphic should be a vertical 'banner' type graphic that is no more than
25% of the total screen width.
Graphic wipe screen width requirements
If the switcher is operating at 1080p then the graphic should be no wider than
1080p
1,920 pixels.
If the switcher is operating at 720p than the graphic should be no wider than
720p
320 pixels.
Manual Transitions
Manual transitions let you manually transition between program and preview sources using the
fader bar in the transition control block. Mix, dip, wipe and DVE transitions can all be performed
as a manual transition.
To perform a manual transition
1
On the preview bus, select the video source that you want on the program output.
2
Select the transition type using the transition type buttons in the transition
control block.
3
Manually move the fader bar from one end to the other to execute the transition.
The next move on the fader bar will begin a new transition.
4
During the transition the red and green buttons on the program and preview buses
both turn red to indicate that you are in the middle of a transition. The LED indicator on
the fader bar also displays the position and progress of the transition.
TIP
You will also see ATEM Software Control mirror the move on the
software panel.
5
At the end of the transition, sources selected on the program and preview buses are
exchanged to indicate that the video source that was on preview is now on program
and vice versa.
Using ATEM 1 M/E Advanced Panel
130

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Atem mini pro

Table des Matières