Setting Audio Input And Output Behaviour - Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation

Supported Video Input Standards
1080p59.94
1080p50
1080p29.97
1080p25
1080p24
1080p23.98
720p59.94
720p50

Setting Audio Input and Output Behaviour

The 'audio' tab lets you control the nature of the audio follow video feature plus set the mic
inputs to mic or line level audio. Microphones typically have weaker signals compared to line
outputs from other audio devices. This means when mic is selected, the input is boosted
slightly to compensate. This also means that if mic is accidentally selected when a line level
input is plugged in, the audio will sound unusually loud. If the audio sounds much louder than it
should be, check that line is selected instead of mic.
Audio Follow Video Behaviour
You can change the nature of the audio follow video feature for when switching sources.
For example, select 'hard cut audio when switching' to allow the the audio from an input to
switch immediately to another. If you want to the audio to smoothly transition over a brief period
of time, select 'add a transition to audio when switching'.
Split Audio
Split a mono input signal into two separate mono channels. This is helpful for mixing a mono
input into both channels on the stereo master output. You can also add a stereo simulation
effect using the advanced Fairlight controls on the audio page.
Click on the desired input checkbox to split the channels for that input.
Changing Switcher Settings 68