Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation page 139

Settings
Pressing the 'settings' button on the home screen opens all settings for your camera control
panel. Navigate through the pages of settings by pressing the arrow soft button. The network
settings, including DHCP and IP address settings, are the first pages in the sequence. These
settings are described in the section that shows how to change network settings when
connecting the camera control panel to your ATEM switcher. Keep reading this section for
information on the additional settings for your camera control panel.
Auxiliary Select
This setting is important for ATEM switchers that have an auxiliary output.
Master Black
Setting the master black setting to on or off enables or disables the master black
control, also known as the pedestal control. This is helpful if you want to lock the
pedestal so it cannot be accidentally adjusted during production. The pedestal is
controlled by turning the ring wheel on the joystick control knob clockwise or counter
clockwise. More information on the joystick control is provided in the following sections.
Brightness
These settings let you adjust the brightness for the buttons, indicators, LEDs and LCDs
on your camera control panel. Rotate the corresponding control knobs for each setting
clockwise or counter clockwise to brighten or dim the lights.
CCU Panel Controls
The panel controls for each CCU are separated into three general sections. These include:
Scene Files and Camera Settings
Scene files are for storing all the camera parameters for each CCU. Camera settings
can be changed such as shutter speed, master gain, white balance and enabling color
bars. More information for these settings, plus the relative and absolute mode settings,
are described in detail in the following 'controlling cameras' section.
The upper section of each CCU is used to store and recall scene files, plus control
camera settings such as shutter speed, master gain, white balance and color bars
Color Balance Controls
The red, green and blue color balance knobs in the panel's mid section are for
adjusting the color balance of the lift, gamma and gain levels. The white controls are for
adjusting the RGB values for the gain, or highlights and the black controls are for
Using ATEM Camera Control Panel 139