Recording Using The Record Buttons; Setting The Hdmi Output Using The Video Out Buttons - Blackmagic Design ATEM Mini Manuel D'installation Et D'utilisation

Recording using the Record Buttons

ATEM Mini Pro lets you record your stream via its USB-C output using an external disk or flash
drive. For example, you can connect a Blackmagic MultiDock 10G and record directly to an SSD.
When the disk indicator above ATEM Mini Pro's record button illuminates green, press the
record button and you are now recording your broadcast to disk. To stop recording, press the
'stop' button.
ATEM Software Control records your stream using H.264 compression with an optimized
compression ratio to provide high quality video without large file sizes.
Press the record button, marked 'rec', to record your
broadcast to an external drive or flash disk via USB-C
Disk Status Indicator
The disk status LED indicator lets you know the status of the recording media. For example,
the indicator illuminates green if the current drive is formatted and ready to record and red
while recording.
Indicators include:
Green
Red
Slowly flashing red
Rapidly flashing red
NOTE To record to an external drive, you first need to format the disk.
Refer to the 'preparing media for recording' section for more information.

Setting the HDMI Output using the Video Out Buttons

The video out buttons on the right side of your ATEM Mini Pro are used to switch sources to the
HDMI output. The default output source is the multiview and you can read more about this
powerful feature later in this section.
Press the video out buttons to switch a source to the HDMI output
Formatted disk is detected and ready to record.
Disk is recording.
Low disk space.
Bad disk performance causing disk to skip frames.
Additional Features on ATEM Mini Pro 16