Prophete CITY Notice D'utilisation page 97

Masquer les pouces Voir aussi pour CITY:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

blade and run in parallel to the large chain ring (
rect the position of the front derailleur if necessary.
2. Switch to the smallest chain ring and the largest pinion of
the rear derailleur to set the swivel range of the front de-
railleur.
3. Turn the screw
107
guide plate
without grinding
107
4. Switch onto the largest chain ring and the smallest sprocket
of the rear derailleur.
5. Adjust the chain with the screw H
the outer guide plate
REMOVING THE REAR WHEEL
1. V-brake rim brake: Disconnect the brake cable
der to take out the wheel more easily later.
Hydraulic rim brake: Open the quick-clamping lever
the rim brake [OPEN].
2. Hydraulic rim brake: Take the brake cylinder
cantilever socket
115
easily later.
3. Loosen the axle nuts on both sides of the rear wheel with
an 15 mm wrench or release the lever of the quick ten-
sioner (depending on equipment).
4. Take off the axle nuts and the washers.
5. Pull out the rear wheel from the drop-out.
INSTALLING THE REAR WHEEL
1. Place the chain on the pinion.
2. Place the rear wheel into the drop-out. Ensure that the
wheel is placed straight in the holder.
3. Push the shifting protection bracket (if present) and the
washers onto the axle.
4. For models without quick clamp: Attach the wheel with the
axle nuts on both sides with an 15 mm wrench. Tighten the
axle nuts (s. chapter Torque specifications).
For models with quick clamp: Close the quick clamp prop-
erly (s. chapter Quick clamp).
5. V-brake rim brake: Connect the brake cable
Hydraulic rim brake: Push the brake cylinder
the cantilever socket
6. Hydraulic rim brake: Close the quick-clamping lever
[CLOSE]. If the lever closes too easily, the quick-clamping
screw must be adjusted (see chapter Brakes).
7. Check that the brake works properly and adjust it if neces-
sary (s. chapter Brake).
9. Set the gearshift (s. chapter Gearshift).
out until the chain runs past the inner
.
110
so that it runs past
108
without grinding.
110
in order to take out the wheel more
.
115
). Cor-
106
in or-
111
of
113
off the
114
again.
111
back onto
114
113
GEARSHIFT
106
107 108
110
109
111
112
113
114
EN 39
115

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

UrbanTrekkingVtt

Table des Matières