Prophete CITY Notice D'utilisation page 86

BRAKE
5. Replace the brake linings
6. Insert the safety pin
that the pin cannot come free of the holder. Use suitable tools
for this (e.g. pliers).
7. Attach the calliper by tightening the two screws
a 5 mm hexagonal socket wrench.
8. Actuate the respective brake several times in order to centre
the new brake linings in the brake calliper. If there are still any
grinding sounds, adjust the brake as described.
MECHANICAL DISC BRAKE
DANGER OF ACCIDENT!
• The maximum brake output is only achieved after a few brake processes
with a new brake disc or brake linings!
DANGER • The brake disc will grow very hot when braking and may cause burns. The
disc edges may also be very sharp and cause cutting injury. Therefore, do
not touch them while the disc is hot or turning.
SETTING THE DISC BRAKE
Settings usually are not necessary at the disc brake system. The brake linings centre inde-
pendently by actuation of the brake levers.
REPLACING THE BRAKE LINING
DANGER OF ACCIDENT AND DAMAGE!
• Replace the brake linings when their thickness is less than 0.5 mm. The bra­
ke output may otherwise drop to complete loss of the brake force and the
brake system may be damaged.
DANGER
1. Loosen the two clamp screws
wrench.
2. Take the brake calliper off from the brake disc.
3. Straighten the curved end of the safety pin
4. Pull out the safety pin
5. Replace the brake linings
6. Insert the safety pin
EN EN 28
.
65
again and bend the open end over so
64
/ of the brake calliper with a 5 mm hexagonal socket
66 69
.
67
.
68
again and bend the open end over so that the pin cannot come free
67
/ with
62 63
. Use a suitable tool for this (e.g. pliers).
67
62
63
64
65