Prophete CITY Notice D'utilisation page 71

STEM WITH ANGLE ADJUSTMENT
DANGER OF DAMAGE AND ACCIDENTS!
• The stem must not be pulled out beyond the mark! The mark of the minimum
insertion depth must not be visible.
DANGER
SETTING THE POSITION AND HEIGHT
1. Loosen the clamp screw
wrench.
2. You can now set the handlebar position or the stem height.
Always observe the mark of the minimum insertion depth
(No warranty if this is not observed!)
3. Tighten the clamp screw
specification (s. chapter Torque specifications).
SET STEM ANGLE
1. Loosen the lateral clamp screw
socket wrench.
2. Now adjust the desired angle at the stem.
3. Then tighten the clamp screw
torque specification (s. chapter Torque specifications).
SETTING THE HANDLEBAR INCLINATION
1. First loosen the clamp block screw of the handlebar
tachment with a 4 or 5 mm hexagonal socket wrench.
2. Adjust the inclination angle of the handlebar.
3. Tighten the clamp block screw again well (s. chapter Torque
specifications).
4. Turn the handlebar attachments (e.g. brake lever) back to the
starting position if necessary.
with a 6 mm hexagon socket
10
again according to the torque
10
with a 6 mm hexagonal
09
again according to the
09
.
11
09
at-
12
HANDLEBAR
10
11
12
EN 13