Prophete CITY Notice D'utilisation page 72

HANDLEBAR
A-HEAD STEM
For the A-Head stem, the handlebar position, the handlebar incli-
nation and, depending on the model, the angle setting may be ad-
justed. The handlebar height, however, cannot be set.
SETTING THE POSITION
1. Loosen the lateral clamp screws
mm hexagonal socket wrench.
2. Align the handlebar.
3. Tighten the clamp screws again well (s. chapter Torque spe-
cifications).
SETTING THE INCLINATION
1. First loosen the clamp spindle screw of the handlebar
sleeve with a 5 mm hexagonal socket wrench.
15
2. Adjust the inclination angle of the handlebar.
3. Turn the handlebar attachments (e.g. brake lever) back to the
starting position.
4. Tighten the clamp spindle screw
Torque specifications).
In order to set the play in the steering, tighten the upper setting
screw with a 5 mm hexagonal socket wrench. The setting
14
screw should be tightened until the bearing is play-free. It does
not need to be tightened firmly necessarily.
SET STEM ANGLE
1. Loosen the lateral clamp screw
agonal socket wrench respectively.
2. Now adjust the desired angle at the stem.
3. Then tighten the clamp screw
torque specification (s. chapter Torque specifications).
EN EN 14
of the stem with a 4 or 5
13
again well (s. chapter
15
/ with a 5 or 6 mm hex-
16 17
/ again according to the
16 17
13
14
15
16
17