Prophete CITY Notice D'utilisation page 94

GEARSHIFT
INSTALLING THE REAR WHEEL
1. Place the actuating lever on the hub of the rear wheel. Ob-
serve that the yellow marks of the actuating lever cover the
yellow marks of the hub (
2. Place the circlip on the actuating lever and turn it by ap-
prox. 45° clockwise (
3. Place the rear wheel into the drop-out.
4. Apply the safety washers on the axle so that the interlock is
in the drop-out (
99
5. Fasten the rear wheel with the axle nuts. Ensure that the
wheel is placed straight in the holder and that the chain is
appropriately tensioned (see chapter Chain tension).
6. Attach the counter-holder bracket on the left side with the
pipe clamp screw connection at the frame (
7. V-brake rim brake: Connect the brake cable
Hydraulic rim brake: Push the brake cylinder
the cantilever socket
8. Hydraulic rim brake: Close the quick-clamping lever
[CLOSE]. If the lever closes too easily, the quick-clamping
screw must be adjusted (see chapter Brakes).
9. Check that the rim brake works properly. Adjust it if neces-
sary (s. chapter Brake).
10. Set the gearshift (s. chapter Setting the gearshift).
EN EN 36
).
98
+ )
97 98
).
.
94
97
).
95
again.
91
back onto
93
98
92
99
95 96
for mounting align the
yellow markings on each
other
ratched
rotate by 45°
monting ring
fix the bracket to the switch arm
properly
ratched yellow marker
align
switching arm
cover
drive unit
note
direction
yellow marker
backup disk
chapping nut