Publicité
Les langues disponibles
Les langues disponibles
7.1.3
FUSE REPLACEMENT
NOTE
Blown fuses can be recognised by the broken metal filament, as shown in the
picture opposite.
Shine a light with a torch in order to see better whether the fuse has blown.
To check the integrity of the fuse or in the event of a malfunction of the tool, perform the following steps:
•
Turn the ON-OFF switch (3) to the OFF position.
•
Disconnect the power cable (18) or remove the battery (24) from the tool.
•
Take out the fuse (3)
•
If the fuse is blown, replace it with a new one of the same amperage (same colour and lettering)
and the same size.
7.1.4
LUBRICATION OF JOINING LINKS
This paragraph contains the information and instructions to be observed when lubricating the connecting links.
Periodically lubricate the connecting links (15) on both sides with a brush.
(*) For the type of grease/lubricant and/or adhesive/sealant recommended, see paragraph 7.3.3.
0310.0419_01
92
Publicité
