NOTE
Disposal must be carried out in accordance with the legislation of the country in which the product is
installed. It is the user's obligation to comply with the regulations in force in his country.
NOTE
In the event of difficulties in the disassembly, demolition and dismantling of the components making up the
product, consult CAMPAGNOLA S.r.l.'s design office, which will indicate the operating methods in
compliance with the principles of safety and environmental protection.
Please also refer to Chapter 4 regarding section "4.2.1 INDICATIONS FOR SPECIAL WASTE"
5.4.1
ADDITIONAL INFORMATION FOR BATTERY DISPOSAL
NOTE: For products not equipped with battery packs or battery systems, please refer to the specific
documentation for their decommissioning or disposal.
6.
USE AND OPERATION
6.1
GENERAL INFORMATION
-
Only use the tool in good visibility conditions. A dimly lit work area may cause accidents. Do not perform
cuts in poor light conditions, like in the dark, at night, at dusk, at dawn or with dust or sand in the air
impeding clear visibility below 2 metres. The areas in which the machine is used must have adequate
lighting of 100 lux with a minimum uniformity of 0.7 over the work area and 50 lux, with uniformity of at
least 0.3, in the immediate vicinity.
-
Do not use the tool in hazardous conditions for the operator, on slippery ground and/or on steep slopes.
-
Always ensure correct posture (legs slightly apart with one foot in front of the other for greater force of action,
upright torso) respecting rest periods on use (one rest period per hour of work is suggested), on changeover
and position during work.
-
Make sure not to get the product wet, immersed or in contact with water, snow, damp surfaces in general in
order to avoid damaging it.
-
Keep children, frail persons, observers or animals at a safe distance and out of the product's range before
operating it in order to avoid damage, danger or injury.
-
Keep the tool away from sources of heat, oil, solvents, and any environmental conditions other than those
indicated in the manual and permitted.
-
Attention is drawn to the fact that in the event of damage or other condition with leakage of battery fluid, there
may be risks to personnel in the event of contact or other situation resulting from such leakage. Do not touch
any liquid from the battery pack. In case of contact, rinse immediately with clean water. If the liquid comes into
contact with your eyes, rinse thoroughly with clean water and immediately seek medical attention.
-
Use the product only for the purposes described. Any other use may cause injuries.
-
Handle and use the product by gripping it completely and firmly with both hands to avoid misuse, injuries,
falls and accidental impacts.
-
Always check that the safety devices are working properly.
-
Before starting the product, make sure that there are no foreign bodies between the moving parts.
-
Follow the manufacturer's instructions for adjustments and lubrication (see chap. 7).
-
Never use the product if it is damaged, wrongly regulated or only partially assembled.
CAUTION
Please refer to the documentation (manual, data sheet or pictograms) supplied with the Lithium battery for
all indications and warnings to be observed and concerning the use of the battery.
0310.0419_01
87