CAMPAGNOLA MASTER Manuel D'utilisation Et D'entretien page 91

7.1.1 TIGHTENING TORQUES
Screws and bolts of different types and sizes must be tightened during maintenance procedures.
The following tables show, depending on the type of screws and/or bolts present, the value of the maximum
tightening torque to be used and observed in order to avoid problems with the product.
Pos. Description
1 Screw M4x16
Screw
2
Ø3.5x20
3 Screw M5x25
4 Screw M5x40
CAUTION
It is forbidden for the operator to carry out maintenance and/or tightening of screws and bolts
reserved for the mechanical maintenance technician or the electrical maintenance technician.
7.1.2
REPLACEMENT OF TEETH
To replace the teeth (13) proceed as follows:
➢ Place the teeth support (14) on a vice and hit the tip of the tooth (13) with a hammer until it slides out of its
seat
➢ Insert the new tooth into place, taking care to butt the plastic tooth against the wall of the tooth support.
0310.0419_01
Function
To lock the harvesting head
and handle on the extension
pole.
To lock the head and handle
covers
To lock the rake support to the
harvesting head
To lock the teeth supports
91
QUALIFIED Tightening
PERSONNEL torque
4 Nm
1.5-2 Nm
5 Nm
5 Nm