Publicité
Les langues disponibles
Les langues disponibles
CAUTION
It should be remembered that certain effects resulting from the exposure of a product to environmental conditions
are the direct consequence of its exposure in sequence to two or more factors or parameters, among which are
particularly critical:
thermal shock, which may result from exposing the product to high temperature conditions immediately
-
after exposure to low temperature conditions or vice versa, or subjecting the product to water (rain, water
jets, snow, immersion, etc. all forbidden conditions) immediately after exposure to high temperature
conditions;
the formation of ice, which may result from exposing the product to below-freezing temperatures
-
immediately before or after exposure to moisture, rain or water due to causes other than rain.
CAUTION
After storing the product within the limits of the above-mentioned conditions, it is required that it be kept in non-
operative condition for approximately 12 hours in order to re-establish the correct ambient temperature conditions
permitted (see paragraph 4.7) so as to avoid damage to the electrical/electronic part as a result of thermal shock,
ice formation or humidity, etc., which may deteriorate or damage these circuits.
NOTE: any conditions other than the above may be indicated in the specific documentation of the
components, where present and supplied. In this case, the instructions in the specific documentation must be
followed.
5.2
PRODUCT ASSEMBLY
The product that this manual refers to comes disassembled.
Proceed to assemble the product as follows.
•
Remove the harvesting head (12) and the eight teeth (13) from the packaging.
•
Insert the teeth with light pressure on the two supports (14), making sure that the locking teeth have come
out of the support.
•
Remove the extension pole from its package.
•
Connect the connectors (10 and 11) coming out of the harvesting head (12) and the extension pole (6).
•
Insert the extension pole inside the harvesting head as far as it will go, paying attention to the anti-rotation
position.
•
Tighten the clamp screws (16) on the head (12) to securely block the extension pole.
•
Take the handle (1 or 2) out of the package.
•
Connect the connectors (9 and 11) coming out of the handle terminal and extension pole.
•
Tighten the screws (16) of the clamp on the handle (1 or 2).
0310.0419_01
83
Publicité
