Front Fork Adjusters - Ducati MULISTRADA 1000DS Mode D'emploi

Front fork adjusters

The front fork used on this motorcycle has rebound,
compression and spring preload adjustment.
This adjustment is done using the outer adjusters:
1) to adjust rebound damping (fig. 32);
2) to adjust spring preload (fig. 32);
3) to adjust compression damping (fig. 33).
E
Place the motorcycle on the side stand and ensure it is
stable.
Turn the adjuster (1) at the top end of each fork leg with a
flat screwdriver to adjust rebound damping.
Turn the adjuster (3) at the rear end of the whel shaft pich
bolts with a flat screwdriver to adjust compression
damping.
As you turn the adjuster (1), you will hear it click; each click
identifies a setting. Adjuster (3) provides stepless
adjustment (screw thread). Tighten the adjuster fully to
achieve the hardest damping. This will be your starting
point; rotate counter clockwise and count the clicks for
setting "1", "2", etc., or note angular rotation of adjuster.
42
1 2
S S
3
2 1
fig. 32
H H
fig. 33