Passenger Seat And Helmet Lock - Ducati MULISTRADA 1000DS Mode D'emploi

Passenger seat and helmet lock

Opening (fig. 28)
Insert the key into the lock (1) and rotate clockwise until
you hear the seat latch click.
Raise the rear end of the seat (2) and slide it off the front
supports in a rearward motion.
Closing
Position the seat over the tank retaining hooks and pull
towards the rear until getting positive engagement.
Push down on the rear end of the seat until you hear the
seat latch click into place.
Pull the seat moderately upwards to make sure it is firmly
engaged.
The hook for the helmet fastening cable is located under
the passenger seat. Thread the cable (A) through the
helmet and hook its ends onto the hook. Leave the helmet
hanging on the left side (fig. 29) and refit the seat to secure
helmet in place.
Warning
This system is intended to lock your helmet safely
when you park your motorcycle. Never leave the helmet
hanging from the hook when riding or it may get in the way
and make you lose control of the motorcycle.
Hand the cable on the left side. At any other position, the
cable will prevent seat closing.
OPEN
1
A
E
fig. 28
fig. 29
39