Ducati MULISTRADA 1000DS Mode D'emploi page 157

Mobile headlight fairing
Loosen the four screws (1) retaining the mobile headlight
fairing to the supports with seals (2).
Remove the headlight fairing complete with windscreen
(fig. 43).
To replace the windscreen, unscrew the screws (3) with
nylon washers (4) using the special Torx wrench, while
locking out rotation of the rubber-coated nuts (5) from
inside the headlight fairing (fig. 43a).
When fitting the new windscreen, tighten the screws (2)
in the centre first.
Check that the seals (2) are in place on the supports,
position the mobile headlight fairing and fit the screws (1)
at the sides to hold it in place.
Tighten the screws (1).
2
1
5
4
3
E
fig. 43
fig. 43a
57