Setting the gear change and rear brake pedals
The gear change and rear brake pedals can be adjusted to
1
3
suit the preferred riding position of each rider.
Adjust the pedals as follows:
Gear change pedal (fig. 25)
Apply an open-end wrench to the flats (2) to lock out
linkage (1) rotation and loosen the check nut (3).
Unscrew the screw (4) to release the linkage (1) from the
E
gear change lever.
2
Turn suitable flat (2) on linkage (1) and rotate until setting
pedal in the desired position.
Secure the gear change lever to the linkage (1) with the
screw (4).
fig. 25
Tighten the check nut (3) onto the linkage (1).
35