Duplicate Keys - Ducati MULISTRADA 1000DS Mode D'emploi

Operation
When the ignition key is turned to OFF, the immobilizer
inhibits engine operation. When the ignition key is turned
back to ON to start the engine (Key-ON), the following
happens:
1) if the CPU recognised the code, the IMMO light (3, fig.
5) on the instrument panel will flash briefly to indicate
that the immobilizer system has recognised the key
code and enabled engine ignition. Press the engine
E
START button
2) If the IMMO light stays on, it means that the code has
not been recognised. When this is the case, turn the
ignition key back to OFF and then to ON again; if the
engine still does not start, try with the other black key.
If the other key does not work out either, contact the
DUCATI Service network.
3) If the IMMO light keeps flashing, it means that an
immobilizer system fault was reset (e.g. through the
override procedure that uses the throttle twistgrip).
Important
Use only one key during the procedure. Failure to do
so might prevent the system from recognising the code of
the key in use.
28
(2, fig. 21) to start the engine;

Duplicate keys

If you need any additional key, contact the DUCATI Service
network with all the keys you have left and your CODE
CARD.
DUCATI Service will program new keys and reprogram
your original keys, up to 8 keys in total.
You may be asked to identify yourself as the legitimate
owner of the motorcycle. Be sure you have any
documents you might need to this end ready.
The codes of any keys not submitted will be wiped off
from the memory to make those keys unserviceable in
case they have been lost.
Note
If you sell your motorcycle, do not forget to give all
keys and the CODE CARD to the new owner.