Procedure To Disable Immobilizer Engine Block Through Throttle Twistgrip - Ducati MULISTRADA 1000DS Mode D'emploi

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it
open.
The EOBD light (5, fig. 6) turns off after 8 seconds.
2) Release the throttle as soon as the EOBD warning
light turns off.
3) EOBD pilot light will flash. It is now necessary to enter
the electronic code indicated on the CODE CARD
delivered to the customer together with the bike.
4) Count the blinks of the EOBD light until you get as
many blinks as the first digit in the electronic code.
Open the throttle fully for 2 seconds and then release.
In this way the input of one figure is acknowledged,
EOBD pilot light comes on and stays on for 4 seconds.
Carry out the same procedure for the following figures
of the code.
If you do not operate the throttle, the EOBD light will
flash 20 times and then stay on steady and you will
have to repeat the procedure starting from step (1).
5) Release the throttle twistgrip, if the code is correct the
following two conditions may occur:
A) the EOBD warning light shall flash signalling that
engine block has been disabled. The warning light
turns off after 4 seconds or if engine revolutions go
over the limit value of 1000 rpm.
B) The IMMO light (3, fig. 5) keeps flashing until the
engine exceeds 1000 rpm, or until engine is restarted.
6) If the code is NOT correct, the EOBD warning light
and the IMMO light stay on and it is then possible to
repeat the procedure, starting from point 2, as many
times as necessary (infinite).
Note
Should the throttle twistgrip be released before the
set time, the warning light turns on again. It is then
necessary to bring the key to OFF and restart the procedure
from point 1.
E
27