Ducati MULISTRADA 1000DS Mode D'emploi page 171

Note for USA version:
Remove the low beam bulb (7) as follows: disconnect
the connector (A) from the wiring, twist bulb body counter
clockwise and extract the burnt-out bulb (fig. 59). Fit a new
bulb with equal rating. On refitting, twist the bulb
clockwise to lock it into place in the bulb holder.
High beam (lower bulb)
Disconnect the connector (8) from the terminals on the
high beam bulb (fig. 60)
Press and squeeze the ends of the clip (9) to release the
clip from the bulb holder.
Lift the clip (9).
7
USA
8
LOCK LOCK
OPEN OPEN
A
fig. 59
9
fig. 60
E
71