Procedure To Disable Immobilizer Engine Block Through Throttle Twistgrip - Ducati MONSTER S4R Manuel D'utilisation Et Entretien

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it open.
The EOBD warning light (7, fig. 4) turns off after 8 seconds.
2) Release the throttle as soon as the EOBD warning light
turns off.
3) The EOBD pilot light will flash. Now enter the electronic
release code shown on the CODE CARD given to the
customer at the time of consignment of the motorcycle by
the dealer.
E
4) Count a number of flashes of the EOBD light equivalent
to the first number of the secret code.
Open full throttle and keep the position for 2 seconds, then
release. In this way the input of one figure is acknowledged,
EOBD pilot light comes on and stays on for 4 seconds.
Repeat the operation until you have entered the final digit.
If you fail to perform any operation with the throttle the
EOBD light will flash 20 times and then illuminate steadily
to inform you that the procedure must be repeated from
step 1.
5) When you release the throttle, if the code was inserted
in the correct way, The EOBD light will flash to indicate
that the engine has been unblocked. The light switches off
after 4 seconds.
6) Should the code NOT be entered correctly the EOBD
light remains lit and the procedure can be repeated starting
from step 1 for as many times as necessary.
16
Notes
Should the throttle twistgrip be released before the
set time, the warning light turns on again.
It is then necessary to bring the key to OFF and restart the
procedure from point (1).