Procedure To Disable Immobilizer Engine Block Through Throttle Twistgrip - Ducati SPORTTOURING ST3 Manuel D'utilisation

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it open.
The EOBD light (5, fig. 6) turns off after 8 seconds.
2) Release the throttle as soon as the EOBD warning light
turns off.
3) EOBD pilot light will flash. It is now necessary to enter
the electronic code indicated on the CODE CARD
delivered to the customer together with the bike.
E 4) Count the blinks of the EOBD light until you get as many
blinks as the first digit in the electronic code. Open the
throttle fully for 2 seconds and then release. In this way
the input of one figure is acknowledged, EOBD pilot light
comes on and stays on for 4 seconds. Carry out the same
procedure for the following figures of the code.
Failure to comply with this procedure, the EOBD pilot light
will flash for 20 times, then will come on steady. Repeat
the procedure starting from step (1).
5) Release the throttle twistgrip, if the code is correct the
following two conditions may occur:
26
A) the EOBD warning light shall flash signalling that
engine block has been disabled. The warning light
turns off after 4 seconds or if engine revolutions go
over the limit value of 1000 rpm.
B) The IMMO light (3, fig. 5) keeps flashing until the
engine exceeds 1000 rpm, or until engine is restarted.
6) If the code is NOT correct, the EOBD warning light and
the IMMO light stay on and it is then possible to repeat the
procedure, starting from point 2, as many times as
necessary (infinite).
Note
Should the throttle twistgrip be released before the
set time, the warning light turns on again. It is then
necessary to bring the key to OFF and restart the
procedure from point (1).