Procedure To Disable Immobilizer Engine Block Through Throttle Twistgrip - Ducati MONSTER 620 Manuel D'utilisation Et Entretien

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it open.
The EOBD warning light (7, fig. 4) turns off after 8
seconds.
2) Release the throttle as soon as the EOBD warning light
turns off.
3) EOBD pilot light will flash. It is now necessary to enter
the electronic code indicated on the CODE CARD
E delivered to the customer together with the bike.
4) Count as many flashes of the EOBD pilot light (7, fig. 4)
as the first digit of the electronic code.
Fully open the throttle for 2 seconds, and release. In this
way the input of one figure is acknowledged, EOBD pilot
light comes on and stays on for 4 seconds. Carry out the
same procedure for the following figures of the code.
Failure to comply with this procedure, the EOBD pilot light
will flash for 20 times, then will come on steady. Repeat
the procedure starting from step (1).
5) Release the throttle twistgrip, if the code is correct, the
EOBD warning light shall flash signalling that engine block
has been disabled. The warning light turns off after 4
seconds. 6) If the code is NOT correct, the EOBD warning
light stays on and it is then possible to turn the key to OFF
and repeat the procedure, starting from point (1), as many
times as necessary (infinite).
16
Note
Should the throttle twistgrip be released before the
set time, the warning light turns on again. It is then
necessary to bring the key to OFF and restart the
procedure from point (1).