CAUTION
For technical features, warnings, maintenance
instructions and any other information relative
to the monitor or PC, see to the relative user
manuals provided with the machine docu-
mentation.
54
ELECTRICAL HOOK-UP
The manufacturer pre-sets the aligner to operate
with a power supply of 230V AC. To alter this set-
ting, contact Corghi SpA Technical Assistance.
WARNING
Any connections to the workshop electrical
board are the customer's responsibility, and
must be made by staff qualified in accordance
with the relevant legal requirements.
54
- The electric hook-up must be suitably rated
in relation to:
• The machine input power, specified on the
machine data plate.
• The distance between the equipment and
the electric hook-up point, so that voltage
drops under full load do not exceed 4% (10%
during start-up) below the rated voltage
specified on the dataplate.
- The user must:
• Fit a power plug in compliance with the cur-
rent regulations on the power supply lead.
• Connect the equipment to its own electri-
cal connection having a specific automatic
differential circuit-breaker, with sensitivity
30 mA.
55
• Fit protection fuses to protect the power
supply line, rated in accordance with the
instructions provided in the general wiring
diagram in this manual.
• Provide the workshop's electrical system
with a grounding circuit in good working
order.
- To prevent the risk of unauthorised usage of
the machine, always disconnect the mains
power supply plug when the machine is not
used (switched off) for long periods.
- If the machine is connected directly to the
mains via the main electrical panel (without a
plug), a key switch or padlockable switch must
be installed to prevent use of the machine by
unauthorised persons.
WARNING
For correct and safe operation of the machine
it must be connected to an efficient ground
connection.
NEVER connect the earth wire to a gas or water
pipe, telephone wire or any other unsuitable
objects.
Operator's manual R.E.M.O. COMPACT