Job Record; Aligning Procedure Count; User File Backup - Corghi R.E.M.O. COMPACT Manuel D'utilisation

JOB RECORD

From the printing stage, access the job record
using the icon. Use of the job record
instead of selection of the vehicle from the da-
tabank can also be set in the set-up.
Another setting that can be made in the set-up
is the type of job record to be used.
Fill in the job record by using the keys as de-
scribed in the "DATABANK MANAGEMENT"
section.
The compulsory fields are highlighted.
WARNING
When a customer or vehicle is selected from
those already on file, the relative data are
loaded in the job record (e.g., when a vehicle
is selected by means of the registration num-
ber, the customer and the vehicle saved in
the vehicle record are automatically loaded).
These data overwrite those entered previously,
so the selected vehicle may be modified in the
databank.
When a new value is entered in the REG.N.,
CHASSIS and CUSTOMER fields, a new record
is automatically opened for data input.
When the job done is saved, the vehicle and
customer records are also automatically updated.

Aligning procedure count

The equipment now features a count of the
number of alignment jobs performed. The count
increases after performance of the ROC proce-
dure, including ROC skip.
To display the count, select the
and icons from the initial screen.

User file backup

From the logo page, select the icons
and -
The page shown in Fig. 57 will open, allowing
you to select the backup or restore procedure
of the data regarding:
• The databank.
• Files of jobs carried out.
• Customer databank.
• Calibration log.
Operator's manual R.E.M.O. COMPACT
Backup procedure:
Select the DATA SAVING icon in the "BackUp Func-
tions" window
• The path for saving (HARD DISK, REMOVABLE
SUPPORTS, etc.).
• The frequency of the autosaves.
• Confirmation of the user before carrying out
the autosaves.
• Saving in compressed format.
Press Continue to save the data. At the end, the
programme returns to the "BackUp Functions"
page. Click on the icon
the LOGO page.
Restore procedure:
Select the DATA RESTORE icon in the "BackUp
Functions" window
opens from where it is possible to select the path
where the data to restore reside:
,
Once the correct path has been selected, the data
regarding the save are shown in the lines below.
Press Continue in order to proceed. A new win-
dow opens where you have to press Continue to
continue with restoring or Cancel to cancel the
operation. When restoring is finished you are
. The following page opens:
to go back to
. The following page
EN
91