Personal Computer - Corghi R.E.M.O. COMPACT Manuel D'utilisation

A) Title (e.g. FRONT AXLE): indicates the pro-
cedure being used.
B) Values measured on the vehicle.
C) Databank values.
D) Graphic comparison between the values
measured and databank values.
F) Type of angles measured at present.
G) HELP: command which recalls the on-line
help function.
H) Icon bar: icons you can use to move around
the program. More information about the
selected icon is provided in the feedback
bar.
I) Feedback bar: displays a help message about
the function of the selected icon.
L) Vehicle name bar: displays the name of the
vehicle selected from the databank. During
selection of the vehicle from the databank,
it shows the market selected.
M) Status bar: view the client-server communi-
cation status and the state of the robotized
unit batteries.
N) Axle value difference: window containing the
value and databank reference for the differ-
ence between the right-hand and left-hand
values of the angle measured. The window
only appears when the databank contains a
reference value.
O) Operating Zone: part of the screen which
displays the working information.
64
Work screen for recording wheel aligners

PERSONAL COMPUTER

Turn on the aligner using the main switch.
Wait a few seconds to allow the monitor to switch
on and the computer to load the program.
The personal computer, and thus the entire wheel
aligner, can only be switched off using the com-
mand provided in the wheel alignment program.
IMPORTANT
Switching off the personal computer without
using the command provided may damage the
software installation.
IMPORTANT
When the aligner is switched off via software, the
PC, monitor and robotised units enter standby
mode. To switch off these devices completely,
use either the relative on and off buttons, or the
PC feeder switch, or cut off the wheel aligner
power supply at the mains.
Keep the original USB pen drives containing
the aligner software for future system updates.
IMPORTANT
The software on the USB PEN DRIVE is the
property of Corghi S.p.A. and can be used only
with the personal computer supplied with the
equipment.
Operator's manual R.E.M.O. COMPACT
23