Maintenance; Scrapping; Environmental Information - Corghi R.E.M.O. COMPACT Manuel D'utilisation

Check that there are no particularly intense light
sources or luminous reflections that could nega-
tively affect the field cameras or field targets
➥ Prevent such light sources or reflections from
affecting the cameras or field targets.
Check that the field and wheel lights, when
controlled, turn on their 4 green LEDs
➥ Call Corghi SpA Technical Assistance centre
if the 4 green LEDs never turn on.
Check that the robotized measuring units and/
or field targets are not subject to mechani-
cal vibrations generated by the surrounding
environment
➥ Prevent any such mechanical vibrations from
affecting the robotized measuring units and/
or field targets.
Necessity to calibrate the system
➥ Call Corghi SpA Technical Assistance Centre
and do not carry out any more measuring
cycles.
The steering wheels come out
bent.
Check that the brake-locking device is cor-
rectly in place
➥ If it is not put it properly in place.
Check that the steering wheel-locking device
is correctly in place and the steering wheel
itself is straight
➥ If it is not, put it properly in place, taking care
that the steering wheel is straight (i.e. perfectly
horizontal).
Keypad
The keypad or mouse/trackball is
not accepting any commands
Cable not connected or incorrectly connected
➥ Check that the cable is plugged properly into
the USB connector on the computer.
Possible breakage of the device
➥ Call Corghi SpA Technical Assistance
WARNING
the "Spare Parts" manual does not authorise
the user to do any work on the machine except
for that specifically described in the operator's
manual, but does enable the user to provide
accurate information to the after-sales service,
in order to reduce service times.
96

MAINTENANCE

WARNING
Corghi cannot be held responsible for any dam-
age or malfunction resulting from the use of
non-original spare parts or accessories
WARNING
Before making any adjustments or performing
maintenance, disconnect the electrical supply
from the machine and make sure that all moving
parts are suitably immobilised.
Do not remove or modify any parts of this equip-
ment except in the case of service interventions.
CAUTION
Keep the working area clean.
Do not clean the machine with compressed air
or jets of water.
When cleaning, take care to avoid creating and
raising dust as far as possible.
Never use solvents to clean the aligner or
targets.
Keep clean, but do not lubricate, the turnplates
and oscillating footboards on which vehicle
alignment is carried out.

SCRAPPING

If the machine is to be scrapped, remove all
electrical, electronic, and plastic components
and dispose of them separately, as provided for
by local legislation.
ENVIRONMENTAL
INFORMATION
The disposal procedure described below must
only applies to machines with the symbol of
the waste bin with a bar across it
their data plates.
This product may contain substances which may
cause damage to the environment and human
health if not disposed of properly.
We are therefore providing you with the informa-
tion below in order to prevent these substances
from being released into the environment, and
to improve the use of natural resources.
Operator's manual R.E.M.O. COMPACT
on