Adjusting The Monitor; Operator Interface - Corghi R.E.M.O. COMPACT Manuel D'utilisation

ADJUSTING THE MONITOR

With the personal computer turned on, operate
the monitor commands (for detailed instructions,
refer to the monitor user manual).

OPERATOR INTERFACE

Commands and information for moving around
the vehicle wheel alignment program.
IMPORTANT
Depending on the country where the aligner is
used some of the software functions proposed
below might not be applicable.
Icons
An icon is a key on the screen which performs a
specific action when it is selected. This function
is the same throughout the procedure.
The icon's function is identified by a graphic
symbol; a brief comment is also provided in
the feedback bar.
Use the ←, →, ↑ and ↓ cursors keys on the key-
pad to navigate to the icons and press ENTER
to select.
If the icon selected has a sub-menu, it will open
vertically and the icon selected will be replaced
by . Use this icon or the ESC key to close
the menu.
identifies additional icons in the menu
for display.
Icons which are not active are plain grey in colour.
Main menu
Start Begins the vehicle alignment
procedure.
Alignment procedure Selects the
wheel alignment procedure: quick, complete
or customised.
Databank and job management Tools
for management of the jobs archive and user
databank.
Operator's manual R.E.M.O. COMPACT
Set-up and maintenance Gives access
to the utility functions for wheel aligner set-up
and maintenance.
Service programs Gives access to
the wheel aligner service and troubleshooting
functions.
Last job Restarts the wheel alignment
procedure by loading the data of the job just
completed.
Shutdown Activates the programme
closure and wheel aligner switch-off procedure.
Help Recalls the information for the
current video page to the screen.
The on-line instructions back up the Operator's
Manual but do not replace it in all respects.
Programme step recall
Diameter selection Recalls input of the
rim diameter to be used in toe measurements
in millimetres / inches.
Chassis height For vehicles where this
is necessary, recalls input of the chassis heights
necessary to obtain the databank references
Steering angle Recalls the steering lock
procedure for measurement of the caster, king pin,
steering angle difference at 20° and maximum
steering angle.
Data summary Recalls the summary of
the vehicle data.
Front axle Recalls the front axle adjust-
ment step.
Rear axle Recalls the rear axle adjust-
ment step.
Data summary and printout Recalls
the job data summary, printout and save step.
.
EN
65