Electrical Hook-Up - Corghi EM 9550 Plus Laserline Manuel D'utilisation

2. Lower the wheel guard;
CAUTION
Lowering the wheel guard enables the launch of
the swinging group with the blocked template
!!!
3. Align the ultrasonic sensor calibration template
to the ultrasonic sensor support and test its
distance using a meter, ie:
a. 295mm (tolerance +/- 5mm)
IMPORTANT: once the ultrasonic sensor is as-
sembled, calibrate the sensor as described in
the paragraph "Calibration of the ultrasonic
width sensor".
After assembling the machine, position it in the
selected place and make sure that the spaces
surrounding it are at least equal to the ones
indicated in fig.10.
EM 9550 Plus - EM 9550 C Plus - Operator's manual
Main working elements of the
9d
A) Automatic diameter and distance measuring arm.
B) Automatic width measuring ultrasonic sensor
(optional)
C) Tower with LCD display.
E) Control keypad.
F) Side flange holder.
G) Top weight tray.
H) Wheel support shaft.
I) Wheel guard.
L) Control pedal C of the automatic wheel
clamping system

ELECTRICAL HOOK-UP

The wheel balancer is set up by the manufacturer
to operate with the power supply available in the
place of installation. The set-up data for each
machine are given on the machine data plate
and on a special label attached to the power
supply connection cable.
Any operations for hooking up to the workshop
electrical board must be carried out only by
qualified technicians in compliance with the
regulations in force, under the responsibility
10
and at the charge of the customer.
machine (fig. 11)
WARNING
10
UK
47